Cummins Three Phase Power Dynamo Diesel Generator

Cummins three phase power dynamo diesel generator

CUMMINS Diesel Generator

A diesel generator is the combination of a diesel engine with an electrical generator (often called an alternator) to generate electrical energy. Diesel generating sets are used in places without connection to the power grid, as emergency power-supply if the grid fails, as well as for more complex applications such as peak-lopping, Grid Support and export to the power grid.

CUMMINS Series Diesel Generator Sets

The packaged combination of a diesel engine, a generator and various ancillary devices (such as base, canopy, sound attenuation, control systems, circuit breakers, jacket water heaters and starting system) is referred to as a "generating set" or a "genset" for short.

Generator sets sizes range from 8 to 30 kW (also 8 to 30 kVA single phase) for homes, small shops & offices with the larger industrial generators from 8 kW (11 kVA) up to 2, 000 kW (2500 kVA three phase) used for large office complexes, factories. In these larger sizes the power module (engine and generator) are brought to site on trailers separately and are connected together with large cables and a control cable to form a complete synchronized power plant.

This is extremely beneficial for both parties - the diesels have already been purchased for other reasons; But to be reliable need to be fully load tested. Grid paralleling is a convenient way of doing this. This method of operation is normally undertaken by a third party aggregator who manages the operation of the generators and the interaction with the system operator.

During normal operation in synchronization with the electricity net power plants are governed with a five percent droop speed control. This means the full load speed is 100% and the no load speed is 105%. This is required for the stable operation of the net without hunting and dropouts of power plants. Normally the changes in speed are minor. Adjustments in power output are made by slowly raising the droop curve by increasing the spring pressure on a centrifugal governor. Generally this is a basic system requirement for all power plants because the older and newer plants have to be compatible in response to the instantaneous changes in frequency without depending on outside communication.

Main Assemblies
1, Diesel Engine (CUMMINS Brand)
2, Generator/Alternator (With AVR)
3, Standard Control Panel (Ordinary Type, LCD Type, ATS Type )
4, Common Base(Including Base Oil Tank)

Standard Accessories
1, Starting Battery and Connector Wire
2, The Vibration Reduction Rubber Gasket
3, Silencer
4, Exhaust Elbow
5, 8-hour Oil Tank
6, Spare Part Case
7, Technical Data
8, Water Tank Radiator, The belt-driving Cooling Fan, Fan Safety Shield
9, Dry-type Air Filter
10, Fuel Filter
11, Lubricating Oil Filter
12, Starting Motor
13, Self-charging Generator
14, Frequency Meter/Water-thermometer/Oil Pressure Gauge/Battery Voltmeter

Optional Accessories
1, Preheating Start System
2, Diesel Engine Thermal Protection System
3, Jacket Heater
4, Speeding, High Temperature, High Oil Temperature, Low Pressure Alarm System
5, Breaker
6, Antifreeze Liquid
7, Ground Wire
8, Water Temperature Safety Device
9, Machine Oil

Service Conditions
-- Ambient Temperature: -25° C~40° C
-- Altitude: Not exceed 1000 Meter
-- Rated Voltage: 230/380V or any voltage between 220-440V
-- Rated Frequency: 50Hz/60Hz
-- Insulation Class: B/F/H
-- Working Duty: S1(Continuous)
-- Humidity: Lower than 95%